About the product
- High Quality Material : This car phone holder is made of high quality ABS material, which is hard and will not deform, and can firmly support the phone. The material of the magnetic suction device is carefully selected N52 strong magnet, which does not affect the phone signal and firmly adsorbs the phone and will not fall off in the bumps.
- Easy Installation : First insert the ball head into the connection hole and tighten the nut to fix the multi-directional ball head. Turn the knob at the bottom to rotate the hook out until the right length, then snap it upside down on the car vent, then reverse the knob to retract the hook until it is tightly fixed. Finally, put the iron piece into the phone case, it will be automatically adsorbed by the bracket.
- Wide Compatibility : The height is 4.8 inches, the diameter of the ball head is 2.4 inches, strong compatibility, suitable for horizontal and vertical air vents, the installation is solid and does not fall off. Can be adsorbed 4-7.2-inch cell phones, built-in 24 rubidium boron magnets, strong suction, with a phone case can also be used.
- Does Not Affect Charging : The phone holder is a ring-shaped magnetic suction design, magnetic ring clings to the back of the phone, will not block your phone charging hole and screen, will not clip the power button like a traditional phone holder, horizontal and vertical angle can be freely adjusted, charging faster.
- One Second Adsorption : Just put your phone on it, it will automatically adsorb, and it is easy to take off, unlike traditional phone holders, no need to open the clip or press the button, effectively free your hands, will not block the windshield or affect your vision, improve driving safety.
No reviews found!
